Replacing The Board Fan; Figure 10-25 System Board Fan - Sun Microsystems Ultra 1 Creator Series Service Manual

FIGURE 10-25
10.6.2

Replacing the Board Fan

Caution – Use proper ESD grounding techniques when handling components. Wear
!
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing it on any surface.
1. Position the replacement system board fan on the system board (
2. Connect the system board fan connector to the system board at J0101.
3. Position the plastic cover on top of the system board fan.
4. Replace the two screws securing the plastic cover and system board fan to the
system board (
10-30 Ultra 1 Creator Series Service Manual • August 1996
System board fan
J0101
System Board Fan
)
FIGURE 10-24
Plastic cover
FIGURE 10-25
).