4. Grasping the sides of the cover, lift the cover up from the rear. After the cover
clears the back panel, push the cover away from the front panel.
FIGURE 7-2
7.2
Attaching the Wrist Strap
To attach the wrist strap:
Caution – Wear an antistatic wrist strap and use an ESD-protected mat when
!
handling components. When removing components other than the power supply,
leave the power cord connected to both the system/server unit and the wall
receptacle. When removing the power supply, attach the copper end of the wrist
strap to the system/server unit chassis, not the power supply. Store
ESD-sensitive components in antistatic bags before placing it on any surface.
1. Unwrap the first two folds of the wrist strap; wrap the adhesive side firmly
against the wrist (
7-2
Ultra 1 Creator Series Service Manual • August 1996
Captive screw (2)
Removing the Cover
FIGURE 7-3
Cover
).