6. Power-on the system.
See Section 6.1 "Powering On the System" on page 6-1.
10.3
SBus Card
To remove and replace the SBus card, proceed as follows.
10.3.1
Removing an SBus Card
Note – If there are two SBus cards in the system and the defective SBus card is
installed in SBus slot 0, perform the following steps to remove the SBus card from
slot 1 followed by the removal of the defective card from slot 0.
1. Power-off the system.
See Section 6.2 "Powering Off the System" on page 6-2.
2. Disconnect all cables from the SBus slots (
UPA slot
System board
FIGURE 10-12
10-14
Ultra 1 Creator Series Service Manual • August 1996
SBus Slot Locations.
).
FIGURE 10-12
SBus slot 1
SBus slot 0