2. Peel the liner from the copper foil at the opposite end of the wrist strap. Attach
the copper end of the wrist strap to the power supply top.
FIGURE 7-3
7.3
Replacing the Cover
To replace the cover:
1. Position the cover on the system (
2. Lower the rear of the cover until the cover channels align with the chassis flanges.
Press down on each side of the cover until the cover firmly seats (
3. Tighten the captive screws securing the cover.
4. Use a No. 1 Phillips screwdriver to replace the lock block (
Copper foil end
Power supply
Attaching the Wrist Strap
Wrist strap
).
FIGURE 7-4
FIGURE 7-4
).
FIGURE 7-1
Chapter 7
Internal Access
).
7-3