Figure 9-8 Positioning The Chassis Bracket - Sun Microsystems Ultra 1 Creator Series Service Manual

2. Position the chassis bracket in the chassis and slide the chassis bracket toward the
opening in the chassis side (
3. Connect the DC harness to the peripheral power cable at P1.
Bottom hole (3)
Positioning the Chassis Bracket
FIGURE 9-8
Note – Hooks at the chassis base must lock into the bottom holes of the drive
bracket.
4. Replace the DC harness as follows (
a. Route the DC harness through the drive bracket clip.
b. Replace the two screws securing the chassis to the chassis bracket.
5. Place the chassis bracket on an antistatic surface.
).
FIGURE 9-8
Chassis bracket
Chassis
):
FIGURE 9-5
Screw (2)
Chapter 9 Storage Devices
P1
Clip
9-9