Removing The Disk Drive Fan Assembly; Figure 8-4 Fan Power Cable Connection - Sun Microsystems Ultra 1 Creator Series Service Manual

8.2.1

Removing the Disk Drive Fan Assembly

1. Power-off the system.
See Section 6.2 "Powering Off the System" on page 6-2.
2. Remove the system unit cover.
See Section 7.1 "Removing the Cover" on page 7-1.
Caution – Use proper ESD grounding techniques when handling components. Wear
!
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing it on any surface.
3. Attach the wrist strap.
See Section 7.2 "Attaching the Wrist Strap" on page 7-2.
4. Disconnect the fan power cable from the fan (
FIGURE 8-4
5. Prepare to remove the fan assembly as follows
8-6 Ultra 1 Creator Series Service Manual • August 1996
Fan power cable
Fan Power Cable Connection
).
FIGURE 8-4
:
FIGURE 8-5
Fan