Replacing The Power Supply; Figure 8-1 Removing And Replacing The Power Supply (Part 1 Of 2) - Sun Microsystems Ultra 60 Service Manual

Peripheral power cable
Power supply
(partially extended)
Captive screw (4)
Removing and Replacing the Power Supply (Part 1 of 2)
FIGURE 8-1
8.1.2

Replacing the Power Supply

Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
1. Replace the power supply as follows ( and ):
FIGURE 8-1 FIGURE 8-2
a. Feed the power supply cables through the chassis opening; support the power
supply cables while engaging the power supply into the chassis rails.
b. Position the power supply into the chassis.
c. Slide the power supply toward the chassis front.
d. Connect the power cables to the motherboard.
e. Connect the peripheral cable connector to the power supply.
f. Replace the peripheral power cable through the cable routing clips.
Chapter 8 Major Subassemblies 8-3