7
7.3 Replacing the Cover
7-4
1. Position the cover on the system as shown.
See Figure 7-4.
Channel
(2 places)
Flange
Captive screws
Figure 7-4
Replacing the Cover
2. Lower the back side of the cover until the channels on both sides of the
cover align with the two flanges on the rear of the system. Press down on
both sides of the cover until it is firmly seated.
See Figure 7-4.
3. Tighten the captive screws on the back panel.
4. Replace the lock block with a Phillips screwdriver.
See Figure 7-1.
Sun Ultra 1 Series Service Manual—November 1995
Flange
Cover