Replacing The Cover; Figure 7-3 Grounding The Wrist Strap To The Power Supply - Sun Microsystems SPARCstation 4 110 Service Manual

FIGURE 7-3
2. Peel the liner from the copper foil at the opposite end of the wrist strap and attach
that end to the top of the power supply.
See
FIGURE 7-3
the power supply; avoid the labels on top of the supply.
7.3

Replacing the Cover

1. Remove the wrist strap from your wrist and then from the power supply.
2. Align the cover hinge tabs with the tab slots on the bottom front of the system
chassis. Carefully lower the cover, making sure that the hinge hooks remain
inside their respective slots.
See
FIGURE 7-4
7-4 SPARCstation 4 Model 110 Service Manual • July 1996
Grounding the Wrist Strap to the Power Supply
. Make sure that the strap makes good contact with the metal casing of
.