4.5.8.2
Installing the Power Supply
To install the power supply:
1. Remove the left-side access panel, if necessary.
2. Gently lay the system on its right side on a stable, non-slip surface.
3. Remove the new power supply from its package.
4. Locate where the power supply is to be installed, and place the power supply
inside the chassis (see
a. Align the power supply IEC-320 connector (power cord socket) and fan with the
chassis back-panel opening.
b. Position the power supply with the chassis power supply brackets.
c. Rotate the power supply down and into the chassis.
FIGURE 4-29
5. Fasten the power supply to the chassis.
FIGURE 4-29
Installing the Power Supply Into the Chassis
).
Chapter 4 Maintaining the Workstation
4-37