Replacing The Disk Drive Mounting Bracket - Sun Microsystems SPARCclassic Service Manual

Figure 9–14

Replacing the Disk Drive Mounting Bracket

To replace the disk drive mounting bracket:
1. Preparation.
Before setting the disk drive bracket flat in the unit top, connect the power cable
to the diskette drive (if present) and the data cable to the hard drive (see Figure
9–15 and Figure 9–16).
2. Install the bracket.
Tilt the disk drive bracket toward the front of the unit. Gently lower the bracket
into position in front of the power supply (see Figure 9–15).
Note -
the unit top. If the bracket is installed incorrectly, you will not be able to insert
diskettes into the diskette drive.
3. Tighten the captive screw.
Tighten the captive Phillips-head screw at the center rear of the bracket to secure
it to the chassis. Be careful not to overtighten the screw or damage may result.
SPARCclassic/SPARCclassic X/SPARCstation LX Service Manual ♦ Revision A, November 1993
94
Detail of Disk Drive Mounting Bracket
The disk drive bracket must engage a securing ridge at the inside front of