5. Push the drive bracket handle down toward the end opposite the connector until
the handle locks into the clip at the end of the drive bracket.
See
FIGURE 9-3
Note – Do not force the handle. If the handle does not move easily into the latched
position, remove the drive and try again.
FIGURE 9-3
6. Detach the wrist strap and replace the cover.
See Chapter 7.
7. Power on the system.
See Section 6.2 "Powering On the System" on page 6-4.
9-4
SPARCstation 4 Model 110 Service Manual • July 1996
.
Replacing the Disk Drive
SCSI connector
Drive bracket
side rails