Table of Contents
Advertisement
1-4. Preparations for safe driving with children in the vehicle
High back type
4
Sit the child in the child restraint system. Fit
the seat belt to the child restraint system
according to the manufacturer' s instructions
and insert the plate into the buckle. Make
sure that the belt is not twisted.
Check that the shoulder belt is correctly posi-
tioned over the child' s shoulder and that the lap
belt is as low as possible.
WARNING
■
When installing a child restraint system
Observe the following precautions. Failure to do so may result in death or serious
injury.
When a booster seat is installed, always ensure that the shoulder belt is positioned
across the center of the child' s shoulder. The belt should be kept away from the child' s
neck, but not so that it could fall off the child' s shoulder.
■
When installing a booster seat
To prevent the belt from going into ALR lock mode, do not fully extend the shoulder
belt. ALR mode causes the belt to tighten only. This could cause injury or discomfort
to the child.
Removing a child restraint system
Press the buckle release button and fully re-
●
tract the seat belt.
When releasing the buckle, the child restraint sys-
tem may spring up due to the rebound of the seat
cushion. Release the buckle while holding down the
child restraint system.
Since the seat belt automatically reels itself, slowly
return it to the stowing position.
66
Advertisement
Table of Contents
