Lexus NX350h 2022 Owner's Manual page 186

2-3. Parking the vehicle
INFORMATION
■
Codes stored in the HomeLink
The registered codes are not erased even if the 12-volt battery cable is disconnected.
●
● If learning fails when registeing a code to a previously registered HomeLink
the registered code will not be erased.
Program the HomeLink
Before programming the HomeLink
During programming, it is possible that garage doors, gates, or other devices
●
may operate. For this reason, make sure that people and objects are clear of the
garage door or other devices to prevent injury or other potential harm.
It is recommended that a new battery be placed in the remote control transmit-
●
ter for more accurate programming.
The battery side of the transmitter must be pointed away from the HomeLink
Garage door opener motors manufactured after 1995 may be equipped with
●
rolling code protection. If this is the case, you may need a stepladder or other
sturdy, safe device to reach the "learn" or "smart" button on the garage door
opener motor.
WARNING
The garage door or other device may operate, so ensure people and objects are out
●
of danger to prevent potential harm.
● Never allow a child to operate or play with the HomeLink
Steps 1 through 3
light will stop flashing and programming will not be able to be completed.
1 Press and release the HomeLink
the HomeLink
184
®
memory
®
must be performed within 60 seconds. Otherwise the indicator
®
indicator light flashes orange.
®
, perform the following:
®
button you want to program and check that
®
®
®
buttons.
button,
buttons.