Table of Contents
Advertisement
If wheel position registration does not complete after driving for 1 hour or more,
•
park the vehicle in a safe place for approximately 15 minutes and then drive the
vehicle again.
If the vehicle is reversed during wheel position registration, all data collected until
●
then will be cleared. Perform driving again.
Setting the tire pressure
In the following situations, it will be necessary to perform the tire inflation pressure
setting procedure of the tire pressure warning system.
When the specified tire inflation pressure has changed, such as due to carried
●
load, etc.
When the tire inflation pressure is changed such as when the tire size is
●
changed.
If the tire inflation pressure has been adjusted to the specified level, perform the tire
inflation setting procedure by selecting specified inflation pressure on the center
display.
When the tire inflation pressure is to be other than specified, such as when tires
other than the specified size are used, etc., set the tire inflation pressure using
the current pressure. Make sure to adjust the tire inflation pressure of each tire
to the appropriate level before performing tire pressure setting. The tire pressure
warning system operates based on this tire inflation pressure.
Related Links
Setting by selecting a specified tire inflation pressure(P. 579)
Setting using the current tire inflation pressure(P. 580)
Setting by selecting a specified tire inflation pressure
1
Start the hybrid system.
The tire inflation pressure cannot be set while the vehicle is moving.
2
Select
on the center display.
3
Select [Vehicle customize].
4
Select [Tire pressure].
5
Select [Set indicated air pressure] and then select the desired front and rear
tire pressures.
8-5. Tire maintenance
579
8
Advertisement
Table of Contents
