Table of Contents
Advertisement
■
Front camera detection
●
In the following situations, the high beams may not be automatically changed to the
shaded high beams:
•
When a vehicle cuts in front of your vehicle
•
When another vehicle crosses in front of the vehicle
When vehicles ahead are repeatedly detected and then hidden due to repeated
•
curves, road dividers or roadside trees
When a vehicle ahead approaches from a far lane
•
When a vehicle ahead is far away
•
When a vehicle ahead has no lights
•
When the lights of a vehicle ahead are dim
•
•
When a vehicle ahead is reflecting strong light, such as the headlights of your
vehicle
•
Situations in which the sensors may not operate properly:
●
The high beams may change to the shaded high beams if a vehicle ahead that is using
fog lights without its headlights turned on is detected.
●
House lights, street lights, traffic signals, and illuminated billboards or signs and other
reflective objects may cause the high beams to change to the shaded high beams,
cause the high beams not to change to the shaded high beams, or change the area
that is not illuminated.
The following may change the speed at which the shaded areas change or the timing
●
at which the headlights change to the low beams:
The brightness of lights of vehicles ahead
•
The movement and direction of vehicles ahead
•
The distance between the vehicle and a vehicle ahead
•
•
When a vehicle ahead only has lights illuminated on one side
•
When a vehicle ahead is a two-wheeled vehicle
•
The condition of the road (gradient, curve, condition of the road surface, etc.)
•
The number of passengers and amount of luggage
●
The light distribution control of the headlights may not match the driver's expectations
Bicycles and other small vehicles may not be detected.
●
●
In the following situations, the system may not be able to correctly detect the bright-
ness of the surroundings. This may cause the low beams to remain on or the high
beams to flash or dazzle pedestrians or vehicles ahead. In such a case, it is necessary
to manually change between the high beams and low beams.
•
When there are lights similar to headlights or tail lights in the surrounding area
3-1. Driving when the surrounding area is dark
→ P.346
3
201
Advertisement
Table of Contents
