Table of Contents
Advertisement
8-5. Tire maintenance
INFORMATION
●
ID codes can be registered by yourself, but depending on the driving conditions and
driving environment, registration may take some time to complete.
When using a wheel set which all of the ID codes have already been registered, the
●
wheel set can be changed in a short amount of time.
Before performing ID code registration, make sure that no wheels with tire pres-
sure warning valve and transmitters installed are near the vehicle.
1
Park the vehicle in a safe place, turn the power switch off and wait 15 minutes or
more.
2
Start the hybrid system.
The ID code registration procedure cannot be performed while the vehicle is moving.
3
Select
on the center display.
4
Select [Vehicle customize].
5
Select [Tire pressure].
6
Check if the desired wheel set ([Set 1] or [Set
2]) is displayed.
ID codes will be registered to the displayed wheel
set.
To change the wheel set to be registered, select
the displayed set, and then select the wheel set
you wish to register.
If ID codes have already been registered for that
wheel set, the tire pressure warning light will slowly blink 3 times, and a message
indicating that change is occurring will be displayed on the multi-information display.
7
Select [New tire registration].
8
Select [Continue].
The tire pressure warning light will slowly blink 3
times and a message indicating that ID code reg-
istration is being performed will be displayed on
the multi-information display. Wheel set changing
will be canceled and registration will begin.
When registration is being performed, the tire
pressure warning light will blink for approximately
1 minute then illuminate and "---" will be displayed for the inflation pressure of each tire
on the multi-information display.
582
Advertisement
Table of Contents
