Table of Contents
Advertisement
WARNING
After inflation of the tire has completed, the sealant may splatter when the hose is
disconnected or some air is let out of the tire.
16
Install the valve cap onto the valve of the emergency repaired tire.
17
Attach the air release cap to the end of the hose.
If the air release cap is not attached, the sealant may leak and dirty the interior of the
vehicle or ones clothes.
18
Temporarily store the bottle in the luggage compartment while it is connected
to the compressor.
19
To spread the liquid sealant evenly within the tire, immediately drive safety for
about 3 miles (5 km) below 50 mph (80 km/h).
WARNING
Observe the following precautions when driving to spread the sealant evenly.
●
Drive the vehicle carefully at a low speed. Be especially careful when turning and
cornering.
●
If the vehicle does not drive straight or you feel a pull through the steering wheel,
stop the vehicle and check the following:
•
Tire condition. The tire may have separated from the wheel.
Tire inflation pressure. If the tire inflation pressure is 19 psi (130 kPa, 1.3 kgf/cm
•
or bar) or below, this may indicate severe tire damage.
20
After driving, stop your vehicle in a safe place on a hard, flat surface and
reconnect the emergency tire puncture repair kit.
Remove the air release cap from the hose before reconnecting the hose.
9-4. If a tire is flat
2
661
9
Advertisement
Table of Contents
