INFORMATION
If the tire pressure warning light does not blink 3 times when starting ID code
registration procedure, the procedure may not have started. Perform the procedure
again from the beginning.
9
Drive straight (with occasional left and right turns) at approximately 25 mph
(40 km/h) or more for approximately 10 to 30 minutes.
When registration is complete, the tire pressure warning light will turn off and a
message indicating that registration has been completed will be displayed on the
multi-information display.
Registration may take longer than normal to complete if the vehicle speed cannot be
maintained at approximately 25 mph (40 km/h) or more. If registration cannot be
completed after driving for 1 hour or more, perform the registration procedure again
from the beginning.
INFORMATION
■
When registering ID codes
●
Normally, wheel position registration can be completed within approximately 30
minutes.
●
ID code registration is performed while driving at a vehicle speed of approximate-
ly 25 mph (40 km/h) or more.
■
If ID codes are not registered easily
●
In the following situations, ID code registration may take longer than usual to be
completed or may not be possible.
•
When the vehicle has not been parked for approximately 15 minutes or more
before being driven
•
Vehicle is not driven at approximately 25 mph (40 km/h) or more
•
Vehicle is driven on unpaved roads
Vehicle is driven near other vehicles and system cannot recognize tire pressure
•
warning valve and transmitters of your vehicle over those of other vehicles
Wheel with tire pressure warning valve and transmitter installed is inside or
•
near the vehicle
If the vehicle is reversed during registration, all data collected until then will be
●
cleared. Perform driving again.
If registration does not complete after driving for 1 hour or more, perform the ID
●
code registration procedure again from the beginning.
If the ID codes cannot be registered even when performing the above procedure,
●
contact your Lexus dealer.
8-5. Tire maintenance
583
8