Lexus NX350h 2022 Owner's Manual page 188

2-3. Parking the vehicle
Press and hold the remote control transmitter button until the HomeLink
light changes from slowly flashing orange to rapidly flashing green (rolling code) or
continuously lit green (fixed code), then release the button.
Programming an entry gate (for U.S.A. owners)/Programming a device in the
●
Canadian market:
Press and release the remote control transmitter button at 2 second intervals, re-
peatedly, until the HomeLink
to rapidly flashing (green) (rolling code) or continuously lit (green) (fixed code).
4 Test the HomeLink
observing the indicator light:
®
● HomeLink
completed. The garage door or other device should operate when a HomeLink
button is pressed and released.
®
● HomeLink
device is equipped with a rolling code. To complete programming, firmly press and
hold the HomeLink
If the garage door or other device does not operate, proceed to
●
rolling code system(→
5 Repeat the steps above to program another device for any of the remaining
®
HomeLink buttons.
Programming a rolling code system
Two or more people may be necessary to complete rolling code programming.
1 Locate the "Learn" or "Smart" button on the
garage door opener motor in the garage.
This button can usually be found where the hang-
ing antenna wire is attached to the unit. The name
and color of the button may vary by manufacturer.
Refer to the owner's manual supplied with the
garage door opener motor for details.
2 Press and release the "Learn" or "Smart" but-
ton.
Perform 3 within 30 seconds after performing 2.
186
®
indicator light changes from slowly flashing (orange)
®
operation by pressing the newly programmed button and
indicator light illuminates: Programming of a fixed code device has
indicator light flashes rapidly: The garage door opener motor or other
®
button for 2 seconds then release it.
P.186).
®
indicator
®
Programming a