Table of Contents
Advertisement
6-2. Using the safe driving support functions
NOTICE
•
When the road surface around the parking space has the same repeating
pattern
When there is a low protrusion on the road surface near the parking space
•
When the parking space is on a slope
•
•
When a camera has been splashed by hot or cold water and the lens has
fogged up
•
When a camera lens is dirty or covered with water droplets
When accessories which obstruct the view of the camera are installed
•
If assistance is ended during registration, perform registration again.
When registering a parking space to the memory function, if the road surface
●
cannot be detected "No available parking space to register" will be displayed.
When using the memory function, make sure to stop immediately in front of
●
the stop position. Otherwise the parking space may not be able to be detected
correctly or assistance may not be provided to the point that the vehicle is fully
parked.
●
Do not use the memory function if a camera has been subjected to a strong impact
or images of the panoramic view monitor are misaligned.
●
If a camera has been replaced, as the installation angle of the camera will have
changed, it will be necessary to reregister parking spaces of the memory function.
Remote control function
■
Function description
A smartphone can be used to remotely operate the parking functions and exit
functions. Also, assistance can be provided to remotely move the vehicle forward
or backward into a garage, etc.
Parking using Remote control function
A smartphone can be used to remotely operate the parking function if the target
parking space can be detected when the vehicle is stopped close and perpendicu-
lar to the center of the parking space. Also, depending on the condition of the
parking space, etc., if it is necessary to change the direction of travel of the vehicle,
the shift position can be changed by assistance control.
1
Stop the vehicle with it aligned near the center of the target parking space.
→ P.450
2
Press the Advanced Park main switch and check that a possible parking space
is displayed on the center
468
display. → P.450
Advertisement
Table of Contents
