Table of Contents
Advertisement
While driving around a curve and a few seconds after driving around a curve
•
•
When turning left/right and an oncoming vehicle is driving in a lane 3 or more lanes
from the vehicle
•
When turning left/right and the direction of the
vehicle differs greatly from the direction traffic
flows in the oncoming lane
•
When turning left/right and approaching a pe-
destrian which was traveling in the same direc-
tion as the vehicle and continues straight
In addition to the preceding, in certain situations, such as the following, the emergency
●
steering assist may not operate properly:
When a detectable object is too close to the vehicle
•
When there is insufficient space to perform evasive steering maneuvers or an
•
obstruction exists in the evasion direction
When there is an oncoming vehicle
•
Changing the pre-collision setting
The pre-collision system can be enabled/disabled through a customize set-
●
ting.→ P.749
The system is enabled each time the power switch is turned to ON.
When the system is disabled, the PCS warning light will illuminate and a mes-
●
sage will be displayed on the multi-information display.
The pre-collision settings can be changed on the customize
●
When the pre-collision warning timing is changed, the emergency steering
●
assist (excluding the active steering function) timing will also be changed. When
[Later] is selected, the emergency steering assist (excluding the active steering
function) will not operate in most cases.
When the dynamic radar cruise control is operating, the pre-collision warning
will operate at the [Earlier] timing, regardless of the user setting.
6-2. Using the safe driving support functions
settings.→ P.749
367
6
Advertisement
Table of Contents
