Configuring Msdp Mesh Group; Configuring The Msdp Connection Retry Period - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide
Table 30-12 Controlling the received source information
Filter off the SA messages from a specified
MSDP peer
Receive the SA messages permitted by the
advanced ACL from a specified MSDP peer
Remove the filtering rule over received
source information
Similar to MSDP outbound filter in function, MSDP inbound filter controls the received
SA messages. By default, the SA messages from all peers are accepted.

30.2.11 Configuring MSDP Mesh Group

Mesh Group is useful when full connection among MSDP peers is required but SA
message flooding shall be prevented.
In a Mesh group, the SA messages from outside the group are forwarded to other
members in the group, but the SA messages from peers inside the group will not be
performed with Peer-RPF check or forwarded in the group. In this case, the overflow of
SA messages is avoided and Peer-RPF is simplified, as BGP or MBGP is not required
between MSDP peers.
Please perform the following configurations in MSDP view.
Table 30-13 Configuring MSDP full connection group
Configure an MSDP peer to be a
member of an MSDP Mesh Group
Delete that member from the Group
If an MSDP peer is configured into different mesh groups, only the last configuration is
valid.

30.2.12 Configuring the MSDP Connection Retry Period

Perform the following configurations in MSDP view.
Operation
Operation
30-10
Chapter 30 MSDP Configuration
Command
peer peer-address
import
peer peer-address
import [ acl acl-number ]
undo peer
sa-policy import
Command
peer peer-address mesh-group name
undo peer peer-address mesh-group
name
sa-policy
sa-policy
peer-address