Creating A New Vlan For The Routed Interface; Mapping The Vsp To The Vlan - Avaya P550R User Manual

Chapter 4
Creating a new
VLAN for the
Routed
Interface
Mapping the
VSP to the VLAN
4-44
6. To create a new VLAN for the routed interface:
* Note: Refer to "Creating a VLAN" in Chapter 4, "Using
VLANs, Spanning Tree, Hunt Groups, and VTP
Snooping" in the Avaya P550R/P580/P880/P882
Switch User Guide for more information.
l. Select L2 Switching > VLANs > Configuration from
the Web Agent. The VLAN Configuration dialog box
opens.
m. Click CREATE. The Create VLAN dialog box opens.
n. Enter a Name for the VLAN in the Name field.
o. Enter an unused VLAN ID (between 1 and 4095) in the
ID field.
p. Select an Initial Hash Table Size from the pull-down
menu. The Default is 1024.
q. Select an Auto-Increment HT Size from the pull-down
menu. The Default is TRUE.
r. Click Apply to save your changes, or Cancel to restore
previous settings.
7. To map the VSP to the VLAN:
a. Select Modules & Ports > Configuration from the Web
Agent. The Module Information dialog box opens.
b. Click the number of the switch port in the Switch Ports
column of the ATM Uplink module you want to view the
module information for. The Switch Ports dialog box
opens.
c. Select the switch port from the "Name" column. The
Switch Port for <xxx> dialog box opens.
d. Select the VLAN (created in step 6) you want to route
from the Port VLAN pull-down menu.
e. Select Enable or Disable from the "Allow Learning"
pull-down menu.
f. Select Disable from the "Spanning Tree Mode" pull-down
menu.
g. "Fast Start" is not supported by the ATM Uplink Module,
leave this setting Disabled.
Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink User Guide, Version 2.0.