Avaya P550R User Manual page 30

Chapter 2
2-6
Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink Module User Guide, Version 2.0
Table 6. ATM Module Information Parameters
Parameter Definition
Module Status The ATM Uplink module status. States include:
Boot Version The version of the boot image software.
APP1 The image version on APP1.
APP2 The image version on APP2.
Desired App Select the application image on the module that
you want to boot from. Options include:
Note:
MAC Flush This governs how often the supervisor module
Timer updates the ATM Uplink module's copy of the
Address Forwarding Table (AFT) with MAC adds
and deletes.
30 Seconds is the default setting.
It is recommended that the default setting not be
changed. Further, this value should always less
than or equal to the Age Time of the AFT.
• Waiting Init - The module is in setup
mode.
• Initializing - The module is sending
packets to connected devices.
• Running Diagnostics - The module is
running internal diagnostics.
• No Valid Image - The image may be
corrupted. Download a new image.
• Booting Image - The module is booting
up.
• Active - The module is ready.
• App1
• App2
• Boot - Use only if App1 and App2 are
corrupted.
Boot is not a fully functional image.
Boot will allow you to start the ATM
Uplink module in the event that App1
and/or App2 have been corrupted. It
will enable you to download a new
Application code.