Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink Module User Guide, Version 2.0
Figure 54. Switch Port Configuration Dialog Box
4. Use the parameters described in Table 55 to configure your
switch port.
Table 55. Switch Port Configuration Parameters
Parameter
Port VLAN
Allow Learning
Spanning Tree
Mode
Fast Start
Definition
Select the VLAN assignment for this switch
port. The default value is Discard (no VLAN).
Note:
Only one LEC per VLAN is permitted.
Select Enable or Disable the port's learning of
new addresses. The default value is Enable.
Select Enable or Disable spanning tree protocol
on this port. The default value is Enable.
See
Spanning Tree
in
Chapter 1
on how a LEC is displayed with regards to
Spanning Tree.
Note:
For RFC1483 VSPs, Spanning Tree
Mode should be disabled.
Fast Start is not supported. The default value is
Disable. Leave this Disabled.
Configuring LANE
for information
3-41