Avaya P550R User Manual page 136

Chapter 4
4-46
Parameter
VLAN
Network
Address
Mask
MAC Format
ARP Timeout
Directed
Broadcast
IP Routing
RIP
OSPF
Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink User Guide, Version 2.0.
Definition
Specify the type of VLAN. Options include:
• Default - Selects the default VLAN.
• Discard - Selects the VLAN to be discarded.
• Ethernet-Console - Selects the Ethernet
Console port as the VLAN.
• Serial Console - Selects the Serial Console
port as the VLAN.
Note:
This must be set for routed VSPs.
Enter the routed IP address attached to the VLAN
the ATM Uplink module is on. The unique IP
address is on a unique subnet.
Note:
This must be set for routed VSPs.
Enter the subnet mask for the interface.
Note:
This must be set for routed VSPs.
Select the MAC address format for the interface.
Options include:
• Ethernet V2
• Simple Network Access Protocol (SNAP)
Enter the ARP timeout value. The default is 360
seconds.
Select Enable or Disable.
Select enable or disable IP routing on the interface.
Options include:
• Routing/Mgmt - Enables you to manage
the switch, from the Command Line
Interface (CLI) or the Web Agent, and
configure IP routing for the switch.
• Mgmt Only - Enables you to manage the
switch, however, IP routing is disabled.
• Default - Enables you to configure IP
Routing for the switch, however you cannot
configure a Routing Only interface.
Note:
When you select Default, it automatically
defaults to Routing/Mgmt:
Enable or disable RIP. The default value is Disable.
Enable or disable OSPF. The default value is
Disable.