Setting Up A Static Arp Entry - Avaya P550R User Manual

Setting up a
Static ARP Entry
Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink User Guide, Version 2.0.
Parameter Definition
Multicast Specify the multicast protocol for the interface.
Protocol Options include:
Proxy ARP Enable or disable Proxy ARP. The default value is
Disable.
ICMP Redirect Enable or disable ICMP Redirect (IDRP). The
default value is Enable.
NetBIOS UDP Enable or disable NetBIOS UDP Rebroadcasts. The
Rebroadcast default value is Disable.
VRRP Enable or disable Virtual Redundancy Router
Protocol. The default value is Disable.
BOOTP/DHCP Enable or disable the BOOTP/DHCP Relay Agent.
Relay Gateway The default value is Disable.
* Note: Steps 9-11 only need to be completed if the interface is
not using a Routed protocol.
9. To set up a Static ARP entry for the remote IP Routing
interface, with the MAC address of the ATM Uplink module:
* Note: If you are using OSPF on the Routed Interface
attached to the LLC Routed VSP, do not run this
procedure.
* Note: Refer to "Creating an IP Static ARP Entries" in
Chapter 9, "Configuring IP Routing" in the
Avaya P550R/P580/P880/P882 Switch User Guide
for more information.
a. Select Routing > IP > Configuration > Static ARP from
the Web Agent. The IP Static ARP Entries dialog box
opens.
b. Select CREATE. The Add IP Static ARP Entry dialog
box opens.
c. Enter the IP address of the remote ATM Uplink module to
associate with the Static ARP entry.
d. Enter the MAC address of the local ATM Uplink module.
e. Click CREATE to save your changes, or CANCEL to
restore previous settings.
• None
• DVMRP
• IGMP
Configuring RFC 1483
4-47