Avaya P550R User Manual page 139

Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink User Guide, Version 2.0.
* Notes:
• Refer to "Creating IP Static Routes" in Chapter 9,
"Configuring IP Routing" in the Avaya P550R/P580/
P880/P882 Switch User Guide for more information.
• Set up a Static Route only if you are not using a
routing protocol. If you are using a routed protocol,
repeat steps 1-9 on the second Avaya switch.
a. Select Routing > IP > Configuration > Static Routes
from the Web Agent. The IP Static Routes dialog box
opens.
b. Select Create. The Add IP Static Route dialog box opens.
c. Enter the IP network address of the remote ATM Uplink
module.
d. Refer to Table 90
Table 90. Static Route Parameters
Parameter
Network Address
Mask
Next-Hop Address
Next-Hop
Interface
Cost
Preference
e. Click CREATE to save your changes, or CANCEL to
restore previous settings.
12. Repeat Steps 1-12 (1-9 if you are using a routing protocol)
on the second Avaya switch.
to configure the static route.
Description
Enter an IP network address for your IP static
route.
Enter an IP subnet mask for your IP static
route.
Enter an IP address for the gateway associated
with the IP static route.
Enter an interface that is associated with the IP
static route.
Enter the metric between this router and the
destination. The metric you enter overrides
routing protocol metrics.
Select a Low or High routing preference from
the Preference pull-down menu.
Configuring RFC 1483
4-49