Removing And Installing Camshaft Housing - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
– Unscrew adjusting valve -2-.
Install
Installation is performed in the reverse order, pay attention to the
following points:
Note
Replace gasket ring.
– Install top toothed belt guard
⇒ "1.8 Removing and installing top toothed belt guard",
page 45 .
Tightening torques
♦ ⇒ "2.1 Assembly overview - valve gear", page 104
♦ Sound dampening system - Summary of components ⇒ Body
Work; Rep. gr. 50 .
2.6 Removing and installing camshaft hous‐
ing
Special tools and workshop equipment required
♦ Silicone sealant ⇒ ETKA - Electronic Catalogue of Original
Parts
♦ Sealant remover gasket stripper (bearing code GST, bearing
article no. R 34402), manufacturer Retech s.r.o.
♦ Cleaning and degreasing agent , e.g. -D 009 401 04-
♦ Protective goggles and gloves
Removing
• Cylinder head fitted.
– Remove the toothed belt from the camshaft
⇒ "1.10 Remove the toothed belt from the camshaft",
page 49 .
– Remove cylinder head cover
⇒ "1.2 Removing and installing cylinder head cover",
page 86 .
– Remove fuel distributor
⇒ "2.10 Removing and installing the fuel distributor",
page 336 .
– Remove left coolant pipe
⇒ "3.6 Remove and install the left coolant pipes", page 178
– Release screws -arrows-, push the right charge air pipe slight‐
ly to the side.
– Disconnect the plug connection -2- for hall sender - G40- .
114
Rep. gr.15 - Cylinder head, valve gear
.