Toyota TERCEL 1985 Repair Manual page 87

EM-56 ENGINE MECHANICAL - Cylinder Block
18. CONNECT FOLLOWING WIRES:
(a) Heater inlet and outlet hoses
(b) Fuel pump inlet and return hoses
(c) Brake booster hose
(d) Vacuum hose of VSV for ilde-up
(e) Emission control hose (See system layout in the
emission control section or the layout printed under
the hood.)
19. ( w / A / T )
CONNECT THROTTLE LINKAGE FOR AUTOMATIC
TRANSMISSION (A/T)
20. CONNECT ACCERATOR CABLE
2 1 . CONNECT FOLLOWING CONNECTORS AND WIRES:
(a) Carburetor connector
(b) [3A-C (ex. Canadá Wagón M/T)]
• Ox sensor connector
(c) (w/ A/T)
Water temperature waming switch connector
(d) Water temperature sender gauge connector
(e) Oil pressure switch connector
(f) Distributor connector
(g) Starter connector and wire
(h) Altemator connector and wire
(i)
(j)
22. ( w / P S )
INSTALL POWER STEERING (PS) PUMP
(See page SR-30)
Torque:
23. ( w / A / C )
INSTALL A/C COMPRESSOR (See page AC-30)
24. ( w / A / C )
INSTALL A/C CONDENSER FAN
25. INSTALL RADIATOR (See page CO-17)
26. TAKE OFF SHOP TOWELS FROM BOTH DRIVE
SHAFTS
27. INSTALL AIR CLEANER ASSEMBLY
(See page FU-24)
28. CONNECT CABLE TO NEGATIVE TERMINAL
OF BATTERY
29. FILL WITH ENGINE COOLANT (See page CO-3)
30. FILL WITH ENGINE OIL (See page LU-3)
• Thermo switch connector
• CMH relay connector
Ground wire from left side of cylinder block
Ground wire from dash panel
375 kg-cm (27 ft-lb, 37 N m )