Toyota TERCEL 1985 Repair Manual page 15

M A - 4
Nippondenso
CORRECT WRONG
CORRECT
Clearance
T
Nippondenso
MAlNTENANCE — Maintenance Operations
MAINTENANCE OPERATIONS
ENGINE
Cold Engine Operations
1.
Borroughs
EC0003 EC0004 EC0001
WRONG
CH0084
2.
WRONG
i i i w m i i
llllll'IMI
lllllllllll
mili
Illilllllll
lllllll
•miiuin
MA0035
Borroughs
EC00Q3 EC0004 EC0001
INSPECT V-RIBBED TYPE DRIVE BELT
(ALTERNATOR)
(a) Visually check the belt for separation of the adhesive
rubber above and below the core, core separation
from the belt side, severed core, separation of the rib
from the adhesive rubber, cracking or separation of
the ribs, tom or w o m ribs or cracks in the inner ridges
of the ribs.
If necessary, replace the drive belt.
(b) Using a belt tensión gauge, check the drive belt ten-
sión.
Belt tensión gauge:
Nippondenso BTG-20 (95506-00020) or
Borroughs No. BT-33-73F
Drive belt tensión: Used belt
N e w belt
If necessary, adjust the drive belt tensión.
NOTE:
• "New belt" refers to a brand new belt which has never
been used.
• "Used belt" refers to a belt which has been used on a
running engine for 5 minutes or more.
• After replacing the drive belt, check that if fits properly
in the ribbed grooves, especially in the places difficult
to see.
INSPECT CONVENTIONAL TYPE DRIVE BELTS
(PS PUMP AND A/C COMPRESSOR)
(a) Visually check the drive belt for cracks, oiliness or
wear. Check that the belt does not touch the bottom
of the pulley groove.
If necessary, replace the drive belt.
(b) Using a belt tensión gauge, check the drive belt ten-
sión.
Belt tensión gauge:
Nippondenso BTG-20 (95506-00020) or
Borroughs No. BT-33-73F
Used belt
Drive belt tensión
New belt
If necessary, adjust the drive belt tensión.
80 ± 20 Ib
125 ± 25 Ib
80 ± 20 Ib
125 ± 25 Ib