CH-18
CHARGING SYSTEM - Alternator (w/ IC Regulator)
Bearings
1.
Check that the bearing is not rough or worn.
2.
3.
4.
INSPECT FRONT BEARING
IF NECESSARY, REPLACE FRONT BEARING
(a)
Remove the four screws, bearing retainer and bear-
ing.
(b)
Instad the bearing.
(c)
Align the claws of the bearing retainer with the slots
of the drive end frame.
(d)
Insta 11 the bearing retainer with the four screws.
INSPECT REAR BEARING
Check that the bearing is not rough or worn.
IF NECESSARY, REPLACE REAR BEARING
(a)
Using SST, remove the bearing cover and cover.
SST 0 9 8 2 0 - 0 0 0 2 1