Toyota TERCEL 1985 Repair Manual page 216

IGNITION SYSTEM — On-Vehicle Inspection
ON-VEHICLE INSPECTION
SPARK TEST
NOTE:
from the HA to each spark plug.
CRANK ENGINE AND CHECK THAT LIGHT FLASHES
Connect a timing light to the spark plug. If the timing light
does not flash, check the wiring connections, ignition coil,
igniter and distributor.
INSPECTION OF HIGH-TENSION CORDS
1. CAREFULLY REMOVE HIGH-TENSION CORDS BY
RUBBER BOOT FROM SPARK PLUGS
CAUTION:
damage the conductor inside.
2. INSPECT HIGH-TENSION CORD RESISTANCE
Using an ohmmeter, measure the resistance without dis-
connecting the cap.
Máximum resistance:
If resistance is more than máximum, check the termináis.
Replace the high-tension cord and/or distributor cap if
necessary.
INSPECTION OF SPARK PLUGS
1. REMOVE SPARK PLUGS
2. CLEAN AND INSPECT SPARK PLUGS
(a)
(b)
If there is a problem, replace the plugs.
Recommended spark plugs:
Fed.
Calif. & Canadá 3A-C (ex. Wagón M/T)
Canadá 3A-C (Wagón M/T) & 3A
Perform this test to check that there is voltage
Pulling on or bending the cords may
25 kíl/per cord
Clean the spark plugs with a spark plug cleaner or
wire brush.
Inspect the spark plugs for electrode wear, thread
damage and insulator damage.
ND W14EXR-U11 orW16EXR-U11
NGK BPR4EY11 or BPR5EY11
ND W16EXR-U11
NGK BPR5EY11
ND W14EXR-U or W16EXR-U
NGK BPR4EY or BPR5EY
IG-3