Toyota TERCEL 1985 Repair Manual page 174

FU-24
Valve
Air Intake Hose
FUEL SYSTEM - Carburetor
INSTALLATION OF CARBURETOR
(See page FU-5)
1.
2.
3.
4.
5.
6.
PCV Hose
Hose
U V FU0387
INSTALL CARBURETOR
(a) Place the insulator in the intake manifold.
(b) Place the carburetor in position.
(c) Install the EGR vacuum modulator bracket.
(d) Connect the EGR vacuum modulator hose (1).
(e) Clamp the cold mixture heater wire.
(f) Install the carburetor mount nuts.
CONNECT FOLLOWING HOSES TO CARBURETOR:
(a) Fuel inlet hose
(b) Emission control hoses (see system layout in the
emission control section or the layout printed under
the hood)
CONNECT CARBURETOR CONNECTOR
CONNECT ACCELERATOR CABLE
(w/ A/T)
CONNECT THROTTLE LINKAGE
INSTALL AIR CLEANER ASSEMBLY
(a) Connect the HIC hose, and place the air cleamer
assembly in the carburetor.
(b)
Install the two mount bolt and batterfly nut.
(c)
Connect the emission control following hoses:
(1) HAI hose
(2) (Calf. and Canadá 3A-C)
ASV hose
(3) (ex. Fed.)
AS hose
(4) PCV hose
(d) Connect the air intake hose.