Toyota TERCEL 1985 Repair Manual page 85

EM-54
w / M / T
ENGINE MECHANICAL - Cylinder Block
INSTALLATION OF ENGINE
w/ A/T
1. APPLY MOLYBDENUM DISULPHIDE LITHIUM BASE
GREASE (NLGI NO. 2) OR MP GREASE
(a)
(b) Apply MP grease to the following parts:
2. INSTALL GUIDE PIN TO TORQUE CONVERTOR
3. PLACE ENGINE IN VEHICLE
(a)
(b)
(c)
(d)
4. INSTALL STARTER AND TRANSAXLE LOWER
MOUNT BOLTS
(a)
(b)
Torque:
(c)
5. REMOVE GUIDE PIN
6. (w/ A/T)
INSTALL TORQUE CONVERTER MOUNT BOLTS
(See page AT-28)
Torque:
7. INSTALL TORQUE CONVERTER COVER
(See page AT-28)
8. TAKE OUT JACK FROM UNDER TRANSAXLE
(w/ M/T)
Apply molybdenum disulphide lithium base grease to
the input shaft spline.
• (w/ M/T)
Input shaft end
• (w/ M/T)
Front of the reléase bearing
• (w/ A/T)
Center hub of torque converter
Attach the engine hoist chain to the life brackets on
the engine.
Lower the engine into the engine compartment
(w/ A/T)
Align the guide pin with one of the drive píate holes.
Connect the engine and transaxle.
Place the starter in position.
Instad and torque the lower mount bolts.
14 mm bolt head 400 kg-cm (29 ft-lb, 39 Nm)
17 mm bolt head 600 kg-cm (43 ft-lb, 59 Nm)
Remove the hoist chain.
185 kg-cm (13 ft-lb, 18 Nm)