Toyota TERCEL 1985 Repair Manual page 213

LU-8
/<5 v£> O — — ^ v¡¿<—va;
( 1
\v^« <<X——^o^ <^
(pf-D
LUBRICATION SYSTEM - Oil Pump
4.
£^-y\
^
o ^fr f&^/
f% í
LU0077
5.
6.
7.
8.
9.
INSTALL OIL PAN
(a)
Remove any oíd packing material and be careful not
to drop any oil on the contacting surfaces of the oil
pan and cylinder block.
• Using a razor blade and gasket scraper, remove all
the packing (FIPG) material from the gasket surfaces.
• Thoroughly clean all components to remove all the
loóse material.
• Clean both sealing surfaces with a non-residue sol-
vent.
CAUTION: Do not use a solvent which will affect the
painted surfaces.
(b) Apply No. 102 seal packing (Part No. 08826-00080)
or equivalent to the oil pan as shown in the figure.
• Instad a nozzle that has been cut to a 5mm (0.20 in.)
opening.
NOTE: Avoid applying an excess amount to the surface.
Be especially careful near oil passages.
• Parts must be assembled within 15 minutes of
application. Otherwise, the material must be removed
and re-applied.
• Immediately remove nozzle from tube and reinstall
cap.
(c) Instad the oil pan with the nineteen bolts and two
nuts.
Torque: 55 kg-cm (48 in.-lb, 5.4 N-m)
(d) Instad the right and left stiffener plates with the
seven bolts. Torque the bolts.
Torque: 350 kg-cm (25 ft-lb, 34 N-m)
(e) Install the two stabilizer brackets with the four bolts.
Torque the bolts.
Torque: 590 kg-cm (43 ft-lb, 58 N-m)
(f) Install the engine under cover with the four bolts.
LOWER VEHICLE
INSTALL TIMING BELT (See page EM-11)
INSTALL AIR CLEANER
(See step 10 on page FU-27)
INSTALL AND FILL RADIATOR (See page CO-17)
FILL ENGINE OIL (See page LU-3)