Toyota TERCEL 1985 Repair Manual page 222

IGNITION SYSTEM - Integrated Ignition Assembly (HA)
—
/fáS
fíe
N
^ u ( y ^ '
/\£ &'
9. REMOVE BREAKER PLATE
(a) Remove the two screws and píate washers.
(b) Remove the breaker píate.
10. REMOVE GOVERNOR SPRINGS
1 1 . REMOVE SIGNAL ROTOR SHAFT
(a) Remove the grease stopper.
(b) Remove the screw at the end of the governor shaft.
(c) Pulí out the signal rotor shaft.
IG0021
12. REMOVE GOVERNOR WEIGHTS
Using a small screwdriver, remove the E-rings and pulí out
the weights.
INSPECTION OF HA
1. INSPECT BREAKER PLATE
Turn the breaker píate and check that it has a slight drag.
If it sticks or has a strong resistance replace the breaker
píate and the pick-up coil assembly.
2. INSPECT GOVERNOR SHAFT BEARING
Turn the governor shaft and check that the bearing is not
rough or worn.
If it feels rough or worn, replace the HA.
IG-9