Toyota TERCEL 1985 Repair Manual page 261

CHARGING SYSTEM - Alternator (w/ IC Regulator)
Stator
1.
Using an ohmmeter, check that there is continuity be-
tween the coil leads.
If there is no continuity, replace the drive end frame
assembly.
2.
tween the coil leads and drive end frame.
Brushes
1.
2.
INSPECT STATOR FOR OPEN CIRCUIT
INSPECT STATOR FOR GROUND
Using an ohmmeter, check that there is no continuity be-
If there is continuity, replace the drive end frame assemb-
ly.
INSPECT EXPOSED BRUSH LENGH
(a) Using a scale, measure the exposed brush length.
Standard exposed length:
Minimum exposed length:
If the exposed length is less than minimum, replace the
brushes.
IF NECESSARY, REPLACE BRUSHES
(a) Unsolder and remove the brush and spring.
(b) Run the wire of the brush through the hole in the
brush holder, and inserí the spring and brush into the
brush holder.
(c) Solder the brush wire to the brush holder at the
exposed length.
Exposed length: 10.5 mm (0.413 in.)
(d) Check that the brush moves smoothly in the brush
holder.
(e) Cut off the excess wire.
(f) Apply insulation paint to the soldered point.
CH-17
10.5 mm (0.413 in.)
4.5 mm (0.177 in.)