Toyota TERCEL 1985 Repair Manual page 73

EM-42
1, 2 or 3
K^r?* ® ^ ^ = l
/ 2 3 4
^W
\ WJ
(ff)s\X~
^ - . / • ^^^^
ENGINE MECHANICAL - Cylinder Block
4.
t o ^ ^ J ® ^ ^
5.
^
EM0075
(i) Remove the connecting rod cap.
(j) Measure the Plastigage at its widest point.
Standard clearance:
Máximum clearance: 0.08 mm (0.0031 in.)
If the clearance is greater than máximum, replace the
bearing. If necessary, replace the crankshaft
NOTE: If using standard bearing, replace with one having
the same number as maked on the connecting rod cap.
There are three sizes of standard bearings, marked 1, 2
or 3 accordingly.
(k) Completely remove the Plastigage.
REMOVE PISTÓN AND CONNECTING ROD
ASSEMBLIES
(a) Remove all the carbón from the pistón ring ridge.
(b) Cover the connecting rod bolts (See page EM-41)
(c) Push the pistón, connecting rod.assembly and upper
bearing out through the tap of the cylinder.
NOTE:
• Keep the bearings, connecting rod and cap together.
• Arrange the pistón and connecting rod assembly in cor-
rect order.
CHECK CRANKSHAFT THRUST CLEARANCE
Using a dial indicator, measure the thrust clearance while
prying the crankshaft back and forth with a screwdriver.
Standard thrust clearance:
Máximum thrust clearance:
If the clearance is exceeds máximum, replace the thrust
washers as a sel
0.020 - 0.051 mm
(0.0008 - 0.0020 in.)
0.020 - 0.185 mm
(0.0008 - 0.0073 in.)
0.30 mm (0.0118 in.)