Toyota TERCEL 1985 Repair Manual page 163

BATTERY
FU0039
/
5 o^
Passage Bolt
FU0034
FUEL SYSTEM - Carburetor
5. (3A-C)
INSPECT SECOND FUEL CUT SOLENOID VALVE
(a) Connect the solenoid valve body and terminal to the
battery termináis.
(b) You should feel a click from the solenoid valve when
the battery power is connected and disconnected.
If the solenoid valve is not operating properly, replace it.
(c) Replace the O-ring.
6. INSPECT CHOKE HEATER (COIL HOUSING)
Using an ohmmeter, measure the resistance between the
termináis.
Resistance (Cold):
3A-C (ex. Canadá Wagón M/T)
Others
If problem is found, replace the choke heater.
However for a 3A-C engine, replace the air hom assembly.
ASSEMBLY OF CARBURETOR
(See pages FU-5 and 6)
NOTE: Use new gaskets and O-rings throughout.
Assembly of Carburetor Body
(See page FU-6)
1. ASSEMBLE CARBURETOR BODY AND FLANGE
(a) Place the gasket and body onto the flange.
(b) Install the vacuum passage bolt.
(c) Install the three bolts.
2. INSTALL SECONDARY THROTTLE VALVE
DIAPHRAGM
(a) Assemble the secondary throttle valve diaphragm.
(b) Position a new gasket in the carburetor body, and
install the diaphragm assembly.
(c) Connect the link.
3. INSTALL FAST IDLE CAM AND THROTTLE LEVER
(a) Install the fast idle cam with the bolt.
(b) Install the throttle lever with the nut.
(c) Install the throttle back spring.
(d) Install the throttle return spring.
17 - 19 O
20 - 22 ü
FU-13