Toyota TERCEL 1985 Repair Manual page 321

M T - 4 0
Front
Snap Ring Groove
MANUAL TRANSAXLE — Manual Transmission
(Z54F)
REPLACE COUNTER GEAR NO. 2 REAR BEARING
(a)
(b)
SST 0 9 3 0 4 - 1 2 0 1 2
8. REPLACE IDLER GEAR FRONT BEARING
(a)
(b)
SST 0 9 9 5 0 - 0 0 0 2 0
(c)
SST 09506-30011
HSST
ZM0088 ZM0096
Select a rear snap ring that will allow mínimum axial
play and install it on the shaft.
Snap ring thickness
1.925 - 1.975 (0.0758 - 0.0778)
1.975 - 2.025 (0.0778 - 0.0797)
2.025 - 2.075 (0.0797 - 0.0817)
2.075 - 2.125 (0.0817 - 0.0837)
2.125 - 2.175 (0.0837 - 0.0856)
2.175 - 2.225 (0.0856 - 0.0876)
Using a 17 mm socket wrench and press, press out
the bearing.
Using SST and a press, press in a new bearing until
its surface is flush with the transfer adaptor edge.
Using snap ring pliers, remove the snap ring.
Using SST and a press, press out the bearing.
Using SST and a press, press in a new bearing.
mm un.,