Toyota TERCEL 1985 Repair Manual page 312

MANUAL TRANSAXLE — Manual Transmission
25. CHECK EACH GEAR THRUST CLEARANCE
fl
ZM0135
(c) Using a plastic-faced hammer, tap the idler gear and
output shaft halfway out from the intermedíate.
NOTE: Support the gear shaft by hand.
(d) Using a plastic-faced hammer, tap the idler gear to
remove the idler gear, reverse idler gear and reverse
idler gear shaft together.
(e) Using a plastic-faced hammer, tap the output shaft
to remove the output shaft and
together
NOTE: Support the gear and shaft by hand.
(a) Using a dial indicator, measure the 1st and 4th gear
thrust clearances and record the result for later
reference.
Standard clearance:
1 st gear 0.150 - 0.275 mm
( 0 . 0 0 5 9 - 0.0108 in.)
4th gear 0.020 - 0.0240 mm
(0.0008 - 0.0094 in.)
Máximum clearance:
(b) Using a feeier gauge, measure the 2nd and 3rd gear
thrust clearances and record the resuld for later
reference.
Standard clearance:
Máximum clearance:
counter gear
0.30 mm (0.0118 in.)
0.150 - 0.250 mm
(0.0059 - 0.0098 in.)
0.30 mm (0.0118 in.)
MT-31