Toyota TERCEL 1985 Repair Manual page 168

FU-18
JS|
y'
/
2 1
((
4 3
\
\
^ = ^
FUEL SYSTEM - Carburetor
8.
10. INSTALL COIL HOUSING AND SECOND FUEL CUT
s
\
1
)
1C-4-2
1 1 . CONNECT CHOKE OPENER LINK
12. INSTALL EIGHT SCREWS TOGETHER WITH OTHER
13. INSTALL ACCERELATOR PUMP ARM
INSTALL NEEDLE VALVE AND FLOAT
(a) Install the needle valve into the seat.
(b) Insert the float lip between the plunger and clip, and
install the float with the pivot pin.
ASSEMBLE AIR HORN AND BODY
Install the solenoid valves with new gaskets into the car-
buretor body. Clamp the wire for the secondary solenoid
valve (3A-C) to the throttle positioner bracket.
SOLENOID VALVE (3A-C) WIRES TO CONNECTOR
USA (1) 1st fuel cut solenoid valve
(Black and white)
(2) Coil housing (Red)
(3) 1 st fuel cut solenoid valve(Black)
(4) 2nd fuel cut solenoid valve (Black)
Canadá (1) 2nd fuel cut solenoid valve
(White and black)
(2) Coil housing (Red)
(3) 2nd fuel cut solenoid valve (Black)
(4) 1 st fuel cut solenoid valve (Black)
PARTS AS FOLLOWS:
(a) Choke and solenoid wire clamp
(b) Choke and solenoid wire clamp
(c) Solenoid wire clamp (3A-C)
(d) Choke opener link guide
(e) • Choke opener link cover (3A-C)
• Number píate (3A)
(f) Number píate (3A-C)
Install the pump arm to the air hom with the pump plunger
hole and lever end aligned.