Toyota TERCEL 1985 Repair Manual page 82

ENGINE MECHANICAL - Cylinder Block
f Front
Expander
Side Rail
(c) Position the pistón rings so that the ring ends are as
shown.
CAUTION: Do not align the end gaps.
3. INSTALL BEARINGS
Install the bearings ¡n the connecting rods and rod caps.
CAUTION: Install the bearing with the oil hole in the
connecting rod.
ASSEMBLY OF CYLINDER BLOCK
(See page EM-36)
NOTE:
• Thoroughly clean all parts to be assembled.
• Before installing the parts, apply new engine oil to all
sliding and rotaing surfaces.
• Replace all gaskets, and oil seáis with new parts.
1. INSTALL MAIN BEARINGS
Install the bearing in the cylinder block and bearing caps.
CAUTION: Install the bearing with the oil hole in the
block.
2. INSTALL UPPER THRUST WASHERS
Install the thrust washers under the No. 3 main bearing
cap position of the block with the oil grooves facing out-
ward.
3. PLACE CRANKSHAFT ON CYLINDER BLOCK
EM-51