Toyota TERCEL 1985 Repair Manual page 83

EM-52
J^QV
TTTT7
Front **•
Front Mark 0 Yimrp^ Ü-—4
\ . í/fír^sjK^
/MüK
Front / < ^ - ^ L 3^ V
^
f
¡ X N
s***^.
pry\
\~J,-
/ ( \ A
/ \ \ \^ \
\
%
~l,!—.
ENGINE MECHANICAL - Cylinder Block
4.
r^Jd^L
5.
l
EM0009
6.
-^c>
"X
^ J ^ ^
/~\ fS~ u'
\ ^
EM0071
INSTALL MAIN BEARING CAPS
NOTE: Each main bearing cap is numbered.
(a) Install the upper thrust washers on the No. 3 main
bearing cap with the oil grooves facing outward.
(b) Install the main bearing caps in numerical o.rder with
the arrows facing forward.
(c) Apply a light coating of engine oil on the threads and
under the connecting rod cap bolt heads.
(d) Install and uniformly tighten the cap bolts in several
passes, in the sequence shown.
Torque: 600 kg-cm (43 ft-lb, 59 N-m)
(e) Check that the crankshaft turns.
(f) Check the crankshaft thrust clearance.
(See page EM-43)
INSTALL PISTÓN AND CONNECTING ROD
ASSEMBLIES
(a) Cover the rod bolts with a short piece of hose to pro-
tech the crankshaft and cylinder bore from damage.
(b) Using a pistón ring compressor, push the correctly
numbered pistón and connecting rod assembly into
the cylinder. Make sure the marks on the connecting
rod and pistón are facing forward.
INSTALL CONNECTING ROD BEARING CAPS
(a) Match the numbered connecting rod cap with the
numbered connecting rod.
(b) Align the marks punched on the connecting rod and
cap and install.
(c) Apply a light coat of the engine oil on the threads and
under the rod nuts.
(d) Install and alternately tighten the connecting rod nuts
and in several passes.
Torque: 500 kg-cm (36 ft-lb, 49 N-m)