Toyota TERCEL 1985 Repair Manual page 65

EM-34
ENGINE MECHANICAL - Cylinder Head
7. INSTALL DISTRIBUTOR
(See steps 1 to 3 on page IG-13)
8. INSTALL SPARK PLUGS
Install the four spark plugs and connect the high-tension
cords.
Torque:
9. INSTALL TIMING BELT UPPER COVER
10. ( w / A / C )
INSTALL A/C IDLE PULLEY BRACKET AND PULLEY
1 1 . INSTALL WATER PUMP PULLEY
12. INSTALL HALF CIRCULAR PLUG AND CYLINDER
HEAD COVER
(a) Install the half circular plug on the cylinder head.
(b) Install the gasket to the cylinder head cover.
(c) Install the cylinder head cover with the seal washer
and cap nuts.
(d) Connect the PCV hose to the PCV valve.
13. CONNECT EXHAUST PIPE TO EXHAUST MANIFOLD
Torque:
14. [3A-C (ex. Canadá Wagón M/T)]
CONNECT Ox SENSOR CONNECTOR
15. CONNECT RADIATOR OUTLET HOSE
16. CONNECT THROTTLE CABLE TO CARBURETOR
17. ( w / A / T )
CONNECT THROTTLE LINK TO CARBURETOR
18. CONNECT FOLLOWING CONNECTORS AND WIRE:
(a) Carburetor connector
(b) [3A-C (ex. Canadá Wagón M/T)]
Thermo switch connector
(c) (w A/T)
Water temperature warning switch connector
(d) Water temperature sender gauge connector
(e) Ground wire
180 kg-cm (13 ft-lb, 18 N-m)
6 3 0 kg-cm (46 ft-lb, 62 N-m)