Toyota TERCEL 1985 Repair Manual page 167

\Ío
/jyái
^
pX
SST
\
N
-
FUEL SYSTEM - Carburetor
(d) Adjust by bending the portion of the float lip marked
(A).
(e) Lift up the float and, using SST, check the clearance
between the needle valve plunger and float lip.
SST 0 9 2 4 0 - 0 0 0 1 4
Float level (lowered position):
FU0390
(f) Adjust by bending the portion of the float lip marked
(B).
(g) After adjusting the float level, remove the float
plunger, spring and needle valve.
(h) Assemble the needle valve, spring and plunger with
the clip.
5. INSTALL POWER PISTÓN
(a) Insta)) the power pistón spring and pistón into the
bore.
(b) Insta» the retainer with the screw.
6. INSTALL ACCELERATION PUMP PLUNGER AND
BOOT
7. INSTALL AIR HORN GASKET ONTO AIR HORN
FU-17
1.67 — 1.99 mm
(0.0657 - 0.0783 in.)