Toyota TERCEL 1985 Repair Manual page 192

CO-8
COOLING SYSTEM - Water Pump
4. INSTALL ROTOR
(a) Install a new packing and seat into the rotor.
(b) Apply a líttle engine oil to the seal and rotor contact
surface.
(c) Using a press, install the rotor on the water pump
bearing shaft.
NOTE: As shown in the figure, the distance from the
rotor edge to the installation surface of the pump body
should be 6.0 mm (0.236 in.).
5.
CHECK WATER PUMP
After assembly, make sure that the rotor rotates smoothly.
6. INSTALL WATER PUMP SUCTION COVER
Instad a new gasket and water pump suction cover with
three bolts. Torque the bolts.
Torque: 95 kg-cm (82 in.-lb, 9.3 Nm)
NOTE: After installing, make sure that the rotor is not in
contact with the water pump suction cover.