Mitsubishi Electric MELSEC iQ-R Series User Manual page 264

CH1 Heating control output cycle setting
Set the pulse cycle (ON/OFF cycle) of the transistor output.
The ON time of the control output cycle is determined by multiplying the control output cycle by the manipulated value for
heating (MVh) (%) calculated by a PID operation. When the manipulated value for heating (MVh) is stable, pulses are
repeatedly output in the same cycle. For details on this area, refer to the following:
Page 261 CH1 Control output cycle setting
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory area name
CH Heating control output cycle setting
CH Heating control output cycle setting (in the Q compatible mode)
CH1 Control response parameter
In the simple two-degree-of-freedom PID control, select the response speed to the change of the set value (SV) from the
following three levels: Slow, Normal, and Fast.
For details on the simple two-degree-of-freedom, refer to the following:
Page 56 Simple Two-degree-of-freedom
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory area name
CH Control response parameter
CH Control response parameter (in the Q compatible mode)
APPX
262
Appendix 3 Buffer Memory Areas
CH1 CH2
504 704
47 79
CH1 CH2
505 705
49 81
CH3 CH4
904 1104
111 143
CH3 CH4
905 1105
113 145